markwoodward615's Space http://markwoodward615.posterous.com Most recent posts at markwoodward615's Space posterous.com Mon, 25 Jun 2012 03:26:00 -0700 How to paint an interior room http://markwoodward615.posterous.com/how-to-paint-an-interior-room http://markwoodward615.posterous.com/how-to-paint-an-interior-room Tape about any other hardware that can't be eliminated.

TOH Tip: Immediately after removing electrical addresses, put the screws again on the fixtures so they don't get lost.
2. Sand all surfaces
Always sand and paint the ceiling entirely (following these very same actions) prior to addressing the walls.

Making use of a pole sander fitted with a hundred and twenty-grit paper, sand the walls (make certain to use a dust mask). Sweep the sander side to side as you work your way from the prime down. Use medium strain, and take care that the head does not flop and gouge the wall. Alter the paper each time the grit gets clogged with dust.

Get rid of bumps or drips on painted molding with a scraper. Then, utilizing a dampened coarse-grit sanding sponge, rough up the surface. Preserve a bucket of warm h2o nearby, and regularly rinse the sponge. Complete with a dampened very good-grit sponge.

Using a wet/dry vacuum, distinct all the dust from the partitions and trim. Clean the walls with a sponge, using warm h2o and dish soap. Scrub greasy or waxy places. Wipe every thing down a single last time with cleanse h2o
3. Fill gaps and holes
Operate a slender bead of caulk above any gaps in which molding meets wall. Moist your finger and smooth the caulk with even stress to force it into the crack and leave a crisp edge.

Using a putty knife, fill any little divots or holes in the partitions. Use patching compound for plaster and joint compound for drywall. Sand the filler clean with a hundred and twenty-grit sandpaper.

Primary the patched spots (or the whole wall if needed). Sand primed locations with a hundred and twenty-grit sandpaper, and wipe cleanse of dust with a damp sponge.

TOH Suggestion: For the greatest management when employing caulk, reduce a ⅛-inch angled opening in the tube's suggestion.
4. Cut in close to edges
Dip a 2½-inch angled brush into a bucket of paint, loading the paint only a third of the way up the bristles. Tap offâ€"don't wipeâ€"the surplus on the side of the bucket. Use the brush to lower in a 2 to 3-inch band of paint at all corners, versus the ceiling, and subsequent to molding this will give the roller some respiration space so it isn't going to bump versus adjacent areas.
five. Run a line of paint alongside the wall
To minimize in, run a line of paint along the wall about an inch absent from the edge. Then turn the brush onto the bristle guidelines, and press down slightly so the longest bristles assemble into a stage. Use this level to draw a mindful line of paint right up to the edge where wall meets trim. As soon as you have a clean line in spot, amount out any weighty regions or drips, then shift on. In purchase to preserve a damp edge, don't perform in as well significant an place at one particular time.

TOH Idea: Never load the brush immediately from the can. Use a thoroughly clean bucket instead, or you threat contaminating your principal paint supply with dust or dried flecks.
phoenix epoxy, phoenix interior painting

Permalink | Leave a comment  »

]]>
http://posterous.com/images/profile/missing-user-75.png http://posterous.com/users/n56G4FLOIMEWu markwoodward615 markwoodward615